I have configured the UC540 FXS with 2 user and 2 fax type extensions.
All the FXS ports can call the IP Sets.
However whenever an IP Set or Analog set tries to call an Analog set I just get a busy tone.
Nothing can call my analog sets.
I'm guessing I'm missing something in the config.
I'd appreciate any pointers.
Did you use TSW (Telephpony Setup Wizard) to configure FXS analog stations?
Did you configure them as User Mode?
What extensions did you assign them?
Here's the current config:
Port Role Sig Ext
0/0/0 User LS 221
0/0/1 FAX LS 222
0/0/2 User LS 223
0/0/3 User LS 224
Ok, now check to see that there is one, and only one ephone-dn for each user mode analog phone.
If you have more that one, we need to remove one.
how did this end up?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: