cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

350
Views
0
Helpful
1
Replies
nmackie
Beginner

Cannot Dial Internationally - Fast Busy Signal

Hello,

I am running a UC560 and we are unable to dial internationally. Specifically we are trying to call Mexico and we receive a fast busy signal on the phone and the SPA504g handset shows "unknown number". The number I am calling works fine from a cell phone so I know the number is correct. I checked the dialplan and even tried adding one specifically for Mexico however I still get the same result. I've also tried setting the permissions on the dialplan for international calls to unrestricted and confirmed that the phones are also set to unrestricted. But still no change.

To dial Mexico we dial 8 (for an outside line) then dial 011 (for an international call) 52 (country code) xxx xxx xxxx (10 digit number)

Here are the dialplans in the system:

UC560 Dialplans.JPG

And here is the Dialplan I tried adding for Mexico:

UC560 Mexico Dialplan.JPG

Anyone have any ideas or need any other information?

Thanks for your help.

1 ACCEPTED SOLUTION

Accepted Solutions
Rob Huffman
Hall of Fame Community Legend

Hi Neil,

There is a special forum/sub-forum for posting queries related

to uc500 issues. I would post this up over there as there are

some great,great peeps who will be able to help you out I'm sure

https://supportforums.cisco.com/community/netpro/small-business/voiceandconferencing/sbcs-uc500

Cheers!

Rob

"Clocks go slow in a place of work
Minutes drag and the hours jerk" 

-The Clash

View solution in original post

1 REPLY 1
Rob Huffman
Hall of Fame Community Legend

Hi Neil,

There is a special forum/sub-forum for posting queries related

to uc500 issues. I would post this up over there as there are

some great,great peeps who will be able to help you out I'm sure

https://supportforums.cisco.com/community/netpro/small-business/voiceandconferencing/sbcs-uc500

Cheers!

Rob

"Clocks go slow in a place of work
Minutes drag and the hours jerk" 

-The Clash

View solution in original post

This widget could not be displayed.