cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
647
Views
0
Helpful
1
Replies

CCA 3.2(2) 8.6.1 - DID not mapping

focusonit
Level 1
Level 1

Hi have setup a virgin UC560 via the wizard and mapped in-dials to extensions PRI port.

Once the config is finished under the users/phones phone extension the DID doesnt map in the edit phone/button window. (although diagnostics call routing does route the number to the extension) and they are displayed correctly in the dial plan.

If I change the extension number to another extension number outside of the range save and then change it back to the original extension the DID is then displayed correctly under the phone view. CLI post view then shows it adding number xxx secondary xxxxx no-reg primary

However if I change or add anything to the DialPlan incoming it removes all the DIDs from all the extensions. (you can see it removing them all in the post CLI view)

Extension rnage 700 - 799 number 88327700 - 88327799

Any ideas - this is a virgin box and repeated twice now.

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

Do a CLI translation based config and have things work solid and predictably.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: