03-07-2013 01:43 AM - edited 03-21-2019 07:04 AM
03-07-2013 03:11 AM
Hello Peter,
Unfortunately it is not supported.
Alternatively you may use the old ATA186 or SPA8800, SPA8000
HTH,
Alex
*Please rate helpful posts
03-07-2013 03:11 AM
Hello Peter,
Unfortunately it is not supported.
Alternatively you may use the old ATA186 or SPA8800, SPA8000
HTH,
Alex
*Please rate helpful posts
03-07-2013 04:35 AM
No one at Distrubution sells the ATA 186
04-03-2013 01:06 AM
So seeing as the ATA186 is end of life.
Does the UC560 Suppot the "SPA112 2 Port Phone Adapter"
04-03-2013 04:13 AM
Peter_sgc wrote:
So seeing as the ATA186 is end of life.
Does the UC560 Suppot the "SPA112 2 Port Phone Adapter"
Same asnwer as above, any SIP based adapter can be used with UC500 or CME.
04-03-2013 04:13 AM
You can use configuring it manually as third-party SIP phone, using CLI.
However the results will not be good as if using FXS port in UC500, or legacy ATA models that support SCCP.
04-03-2013 05:18 AM
Aha, So it's the case of Configuring it via the CCA?
It would need to be a Generic SIP Phone? Does this mean the configuration would need to be done by hand in the CLI of the UC500?
I would use the FXS ports but this is for a remote office where they EXT's are going over a VPN.
So I wanted to break out one of the EXT to an Analouge device for the use of an External Bell.
Prehaps with SNR or Call FWD etc...
04-03-2013 05:27 AM
Hello Peter,
In case of configuring with CCA use SPA8800, SPA8000 as they are the supported ones with CCA.
HTH,
Alex
*Please rate helpful posts
04-03-2013 05:49 AM
Dam, the SPA8000 is a lot more then the SPA112
04-03-2013 06:19 AM
You can do that using a SIP device and SNR to that number. You can also use a device like algo 8180 that comes with a loudspeaker.
I do not know nothing about CCA. I know all works fine with CLI.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide