03-07-2013 01:43 AM - edited 03-21-2019 07:04 AM
03-07-2013 03:11 AM
Hello Peter,
Unfortunately it is not supported.
Alternatively you may use the old ATA186 or SPA8800, SPA8000
HTH,
Alex
*Please rate helpful posts
03-07-2013 03:11 AM
Hello Peter,
Unfortunately it is not supported.
Alternatively you may use the old ATA186 or SPA8800, SPA8000
HTH,
Alex
*Please rate helpful posts
03-07-2013 04:35 AM
No one at Distrubution sells the ATA 186
04-03-2013 01:06 AM
So seeing as the ATA186 is end of life.
Does the UC560 Suppot the "SPA112 2 Port Phone Adapter"
04-03-2013 04:13 AM
Peter_sgc wrote:
So seeing as the ATA186 is end of life.
Does the UC560 Suppot the "SPA112 2 Port Phone Adapter"
Same asnwer as above, any SIP based adapter can be used with UC500 or CME.
04-03-2013 04:13 AM
You can use configuring it manually as third-party SIP phone, using CLI.
However the results will not be good as if using FXS port in UC500, or legacy ATA models that support SCCP.
04-03-2013 05:18 AM
Aha, So it's the case of Configuring it via the CCA?
It would need to be a Generic SIP Phone? Does this mean the configuration would need to be done by hand in the CLI of the UC500?
I would use the FXS ports but this is for a remote office where they EXT's are going over a VPN.
So I wanted to break out one of the EXT to an Analouge device for the use of an External Bell.
Prehaps with SNR or Call FWD etc...
04-03-2013 05:27 AM
Hello Peter,
In case of configuring with CCA use SPA8800, SPA8000 as they are the supported ones with CCA.
HTH,
Alex
*Please rate helpful posts
04-03-2013 05:49 AM
Dam, the SPA8000 is a lot more then the SPA112
04-03-2013 06:19 AM
You can do that using a SIP device and SNR to that number. You can also use a device like algo 8180 that comes with a loudspeaker.
I do not know nothing about CCA. I know all works fine with CLI.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: