Hi,
For a customer, I need to configure a Snombox PA1 on a UC560.
The PA1 is in fact a SIP-device which allows to speak on a PA-system through your phone (you just call the extension of the PA1)
Now, officially, 3rd party SIP-devices are not supported on a UC560.
With a little help on the web and this forum, I have been able to configure the UC560 via CLI and the PA1 has registered with the UC.So far, so good...
But: when I try to call the extension of the PA1, nothing happens. It seems like the UC doesn't recognize the extension 777 (as it does not appear in the CCA)
Config:
voice register global
mode cme
source-address 10.10.0.253 port 5060
max-dn 20
max-pool 10
authenticate register
date-format D/M/Y
file text
create profile sync 0615060624011404
!
voice register dn 1
number 777
allow watch
name PA
label 777
!
voice register pool 1
id mac 0004.1333.0595
number 1 dn 1
dtmf-relay sip-notify
username 777 password 12345
codec g711ulaw
I've even tried to create a dial-peer like below, but that doesn't help
dial-peer voice 5010 voip
description **** PA ****
destination-pattern 777
session protocol sipv2
session target ipv4:10.10.0.253
session transport tcp
dtmf-relay rtp-nte
codec g711ulaw
no vad
Anyone any insight?
Thanks!
