cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1713
Views
0
Helpful
1
Replies

Configure Push-to-talk (PTT) on a 7921G to be used with a URL link.

lukekrouse
Level 1
Level 1

I was reading through some PTT literature and came across a  PushToTalkURL url command. I was wandering if anyone knew how to configure the Thumbbutton to be used as a URL link. I believe that it is possible I just can not find any specific CLI commands on how this is supposed to be done properly. Any help would be greatly appreciated.

Thanks,

Luke

1 Reply 1

cindy toy
Level 7
Level 7

Hi Luke,

The Cisco NetPro forums may have an answer for your question: http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40^1%40%40.2cc28cbc/0#selected_message

Regards,

Cindy Toy

Cisco Small Business Support

Community Manager

Regards, Cindy If my response answered your question, please mark the response as answered. Thank you!
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: