cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1419
Views
0
Helpful
6
Replies

Connect a SPA8800 to a UC540

Israel Vargas
Beginner
Beginner

Hello, anyone can tell me how to connect or integrate a SPA8800 Gateway to a UC540, I set it up as an ATA, but I fail to register with the UC540

6 Replies 6

Alexander Maroukian
Rising star
Rising star

Hello,

This feature should be available in CCA when the new software pack is released expected in May.

HTH,

Alex

Thanks Alexander.

Do you mean the package to be installed at UC? I install the package UC540-8.2.0, is this is going to improve in May?

Hi,

Yes the package for the UC currently is 8.2 (CME 8.1, CUE 8.0.6, IOS 15.1(2)T4) in May the new will be 8.6 (CME 8.6, CUE 8.6, IOS 15.1(4)M4) and with this update you should be able with CCA to use UC500 with the SPA8800.

HTH,

Alex

*Please rate helpful posts

danplacek
Enthusiast
Enthusiast

You can do it via CLI as well, per this document:

https://supportforums.cisco.com/docs/DOC-9465#comment-3143

I've done this quite a bit. It works well for both FXS and FXO.

econsystems
Beginner
Beginner

I am in a similar situation.  The voice mail system of one of my client has died.  I am in the process of ordering a new SIP trunk to be used with a UC560.  But meanwhile I need to make the UC work with atleast 12 inbound pots trunks. Can I use two SPA8800 so I can take 12 inbound pots lines into the UC.

Thanks.

I am fairly certain CCA (and Cisco) will not support that, but it can be done in CLI.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers