Connecting ATA186 to UC540 from remote location

javdakker · ‎09-27-2012

I have a question regarding an ATA 186. I want to connect this ATA 186 to a UC540 wich is on another location.

We have a Cisco 887 on the remote location and i want to make a IP SEC tunnel between the UC540 and the 887.

Is this possible? If yes can i get the ATA186 to work with the UC over this VPN. How do i create this VPN on the UC?

I can not find this option via the CCA tool.

Regards.

Jan-Aart

Alexander Maroukian · ‎09-27-2012

Hello Jan-Aart,

You may create IPsec vpn using the CCA when you go to configure->security-> vpn server.

You may look at the CCA 3.2.1 admin guide page 239.

HTH,

Alex

*Please rate helpful posts

javdakker · ‎10-03-2012

Hello,

I created the VPN on the UC540 using the CCA tool.

Now i still have to connect my 887 router to the UC540, is that done trough IP SEC?

I am not able to get the VPN up and running. Following setup:

2 locations, both in one IP-VPN. So a routable connection between offices.

Loc 1 has a UC540 wit Ip address X on the WAN port.

Loc 2 has a 887 Router with Ip range Y that can reach X.

ATA 186 needs to connect with VLAN100 on the UC (ip range Z)

I need to configure a VPN tunnel between X and Y to be able to reach Z.

What would be the best solution?

Alexander Maroukian · ‎10-04-2012

Hi Jan ,

Please check the examples in this document:

As you have it configured on UC side as server you may configure only 887 as client.

HTH,

Alex