cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

496
Views
0
Helpful
1
Replies
chankins497
Beginner

Deploying UC540 to exsisting Network

Hi

We have a UC540 at our office that we have been using for demo's and testing.

What I need to do for my test is:

Add UC540 and 1 504G phone to the network at the customers main office.

Take another 504G to another office down the street and call between the phones.

The offices are connected by a fibre opic cable.

I am going to do a factory reset on our 540 to get a fresh start.

I don't have very mush info right now and I'm sorry about that.

I was hoping that there where some general guidlines for this procedure.

The 540 cannot be controlling anything since this is just a test to see if we can add it to a network and call the other site.

Thanks in advnace.

Charles

1 REPLY 1
bkwon
Cisco Employee

- setup a UC540 in main office with a 504G phone and enable IPSec VPN(EZVPN or S2S VPN, depends on which SA box use in antother office )server on UC540.

- put a Security Applicance (SR520/SA520/ISA520 or ASA) in the another office and connect the 504G(B)

- basically, establish a VPN tunnel between UC540 and SA box and you can use 504G(B) phone like local.

Create
Recognize Your Peers
Polls
How would you describe your level of technical expertise?