01-22-2012 11:28 AM - edited 03-21-2019 05:14 AM
HI,
I'm using a SPA-504G IP Phone, a SPA-3102 Gateway to my PSTN line, and a 3CX v10 IPBX. I'd like to store DTMF String in my phonebook... How can I do that?
Example:
To forward my line to my cellphone I have to dial 0 (for external line) then *21#
I would like to programm a soft key to send 0w*21# (w stands for a short pause in dialing)
Thx in advance
01-22-2012 11:35 AM
Wrong forum, try "small business - phones".
However i can tell you already thar is not possible to store pauses in speed-dials.
01-22-2012 01:00 PM
thanks anyway... sorry for the missplaced thread
01-22-2012 05:06 PM
Well paolo...
according to the SPA5xx Administration Guide it is possible to store pauses in speedDials using a comma (,)
page 204 in http://www.cisco.com/en/US/docs/voice_ip_comm/csbpipp/ip_phones/administration/guide/spa500_admin.pdf
01-23-2012 09:05 AM
So did you work this out? What I read on page 204 does not seem to have anything to do with pauses.
01-23-2012 09:13 AM
Oups not a comma but a "P"
Extract from PDF File p.204:
For a pause, enter P followed by a number and a space.
The duration of the pause is the specified number of seconds
01-23-2012 09:28 AM
Apologies if my answer is not correct.
But for sure, the matter is better discussed in the appropriate forum, that is not this one.
01-23-2012 01:24 PM
don't worry ^^ thanks anyway I opend a thread in Small Business
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: