cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1502
Views
0
Helpful
3
Replies

Easiest Way to Replace a Phone?

m.castrigno
Beginner
Beginner

I have a 7961 with an expansion module where the screen died on a UC500 system.

I have a replacement phone that I have attached the expansion module and plugged in but of course it needs the configuration assigned to the mac address of the old phone. What is the easiest way to do this?

Can I do it in CCA 3.1? I am guessing not as I configured the first phone using the CLI.

Thanks,              

1 Accepted Solution

Accepted Solutions

I do this quite a bit....

1. Unplug the old phone.

2. conf t

3. ephone <#>

4. reset

5. mac-address

6. ephone-template <#>

7. Plug in new phone

Sometimes you may have to "reset" multiple times for the "mac-address" command to go through. Do NOT plug in the new phone until after this is completed.

View solution in original post

3 Replies 3

m.castrigno
Beginner
Beginner

I am in the cli and I just want to assign the mac-address of the new phone to the old ephone but it wont let me becasue it has already assigned another ephone to that mac address

is there a remove ephone command of some sort?