cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
824
Views
0
Helpful
1
Replies

External Access to UC560 for IMAP

mmurrayinno4
Level 1
Level 1

I would like to set up external access to my UC560 for IMAP for iPhones and Outlook clients. Everything works great on the LAN, not I want to extend it to off-net devices. I have a DNS entry pointing to my static IP. The UC560 is also my edge device to the WAN interface is plugged into the cable modem. What is the config I need on the UC560 as far as NAT and access rules go? My current interface configs are below:

interface GigabitEthernet0/0

description $FW_OUTSIDE$

ip address 24.24.24.24 255.255.255.224

ip access-group 104 in

ip nat outside

ip inspect SDM_LOW out

ip virtual-reassembly in

load-interval 30

duplex auto

speed auto

!

interface Integrated-Service-Engine0/0

description Interface used to manage integrated application modulecue is initialized with default IMAP group

ip unnumbered Vlan90

ip nat inside

ip virtual-reassembly in

service-module ip address 10.1.10.1 255.255.255.252

service-module ip default-gateway 10.1.10.2

interface Vlan90

description $FW_INSIDE$

ip address 10.1.10.2 255.255.255.252

ip access-group 103 in

ip nat inside

ip virtual-reassembly in

1 Reply 1

Hi,

can you please post your ACL 103 and 104.

regards

- Please rate helpful posts -
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: