Finding it difficult to configure my E1 PRI on UC560 router
Good day people. I have been having challenges configuring my E1 PRI on my UC560 router. the last one I did, I could call out but no call gets to me. It keeps saying call rejected. Please can you help me with configuration steps. Both with CCA and CLI. Please I need help urgently.
My E1 controller is active but my configurations are not coming through especially the dial-peers. I am not so good in voice configurations so I need step by step guide. I have always done data, but now I have to do both data and voice on my job. Please help me if you can.
QuestionDear All,I'm currently looking for firmware version 126.96.36.199 for Linksys SPA400 Analog Telephony Gateway. Unfortunately, my device was bricked and I was able to recover it using a recovery tool and recovery firmware version 188.8.131.52 but can't find v...
Change in ASD Automatic Software Download Feature
Dec 13th, 2019
Cisco RV160, 260, 340, and 345 Series Routers
Due to an API change in Cisco’s software download platform the Automatic Download Feature (ASD) on RV series routers will be temporarily ...
SFP Module Support List for RV160x and RV260x Devices
Small form-factor pluggable (SFP) ports are included on the RV160 and 260 routers to allow the use of optical SFP transceiver modules. SFP’s convert the optical signals to electrical signals. SFP’s al...
Welcome and thanks for visiting the Small Business Community Newsletter. This is our first of what we will make a monthly newsletter where you will be provided information on New products and trends, What’s ...