cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
817
Views
0
Helpful
1
Replies
Highlighted
Participant

FXO ports on UC520 dropping incoming calls

Anybody out there have any FXO teaks (US / carrier AT&T) to help eliminate

incoming FXO calls being disconnected by UC500 during answer transfer to auto at

tend extension?

Example:

voice-port 0/1/0

connection plar opx 602

caller-id enable

602 is the auto attend.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Rising star

Hi Michael,

If you have CLI access, can you please provide some Debug information please...I.E

debug vpm signal

debug voip dialpeer

debug ccsip message

Dont forget to turn on terminal motoring "term mon" when doing teh debugs.

If you can capture this info it would be much appreciated.

Also can you please post your configuration file with all sensative information removed.

Cheers,

David.

Cheers, David Trad. **When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *

View solution in original post

1 REPLY 1
Highlighted
Rising star

Hi Michael,

If you have CLI access, can you please provide some Debug information please...I.E

debug vpm signal

debug voip dialpeer

debug ccsip message

Dont forget to turn on terminal motoring "term mon" when doing teh debugs.

If you can capture this info it would be much appreciated.

Also can you please post your configuration file with all sensative information removed.

Cheers,

David.

Cheers, David Trad. **When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *

View solution in original post