05-25-2010 11:57 AM - edited 03-21-2019 02:37 AM
Anybody out there have any FXO teaks (US / carrier AT&T) to help eliminate
incoming FXO calls being disconnected by UC500 during answer transfer to auto at
tend extension?
Example:
voice-port 0/1/0
connection plar opx 602
caller-id enable
602 is the auto attend.
Solved! Go to Solution.
05-25-2010 11:03 PM
Hi Michael,
If you have CLI access, can you please provide some Debug information please...I.E
debug vpm signal
debug voip dialpeer
debug ccsip message
Dont forget to turn on terminal motoring "term mon" when doing teh debugs.
If you can capture this info it would be much appreciated.
Also can you please post your configuration file with all sensative information removed.
Cheers,
David.
05-25-2010 11:03 PM
Hi Michael,
If you have CLI access, can you please provide some Debug information please...I.E
debug vpm signal
debug voip dialpeer
debug ccsip message
Dont forget to turn on terminal motoring "term mon" when doing teh debugs.
If you can capture this info it would be much appreciated.
Also can you please post your configuration file with all sensative information removed.
Cheers,
David.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: