06-07-2010 04:37 PM - edited 03-21-2019 02:39 AM
Is it possible to create pstn trunk groups and use them to specify what extensions call out which fxo ports?
example: extension range 100 places an outbound call which uses any of the ports 0/1/0 - 0/1/3
extension range 200 places an outbound call which uses any of the ports 0/2/0 - 0/2/3
06-07-2010 05:27 PM
Hi there,
There could potentially be more then one way to do this, one of them could be the following:
A caution though, since I have not done this yet I am unsure as to how many Dial-peers the system can handle, maybe if you were to trim them right down to only essential dial-peers, you could have quite a few groups, but i would imagine too many of them will starve the system of resources.
The other possible method is to run Trunk Line Monitoring:
The UC-500 is not good at partitioning, it is not a feature set of the system, the above are work around's and be assured they are not without draw backs, they are also CLI based configuration I am not sure if this could even be done in CCA, further to that I am notoriously bad at following OOB guide lines
Let me know if you require further info on how to do this.
Cheers,
David.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide