cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

G729r8 SPA504g UC560

Peter_sgc_2
Beginner
Beginner

Hello,

I am trying to set a few phones to use G729r8 on our UC560, but each time they make a call and I check the phone status page I can see that they are using G711u still...

How do I force these phones to "Only" use G729r8....

I have enabled the codec on the CCA under the phone settings, and checked that in the CLI I have "codec g722-64 dspfarm-assist" on the ePhone

I have also checked my "Voice Class Codec"

voice class codec 1

codec preference 1 g711ulaw

codec preference 2 g729r8

Does anyone have any advice?

2 REPLIES 2

craig.corbett
Explorer
Explorer

Is this call internally e.g. over a VPN or externally?

If externally check the applicable codec settings on the outbound dial peer.

mcasimirc63
Enthusiast
Enthusiast

Voice Classes are applied to dial peers and you listed the codec preference backwards.

The g.711 codec will provide you with better voice quality than g.729 because of it sampling rate and lack of compression. The compression will also make more use of your processor.

To make the change you are requesting, you would need to change the codec under the ephone template.  g711 is the default codec used.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: