02-02-2010 04:37 PM - edited 03-21-2019 02:06 AM
I am trying to figure out how to set my input gain for my SPA504g phones. I was able to view the phone's website and can see the settings listed there, but can't seem to get into an admin mode. using the http://phoneip/admin just shows the same page as the http://phoneip site. Do I need to somehow enable the admin mode to make these changes or can I change these settings on the phone itself?
03-16-2010 09:23 AM
John, are you using your Cisco SPA504G
with a VoIP service provider, or with your own IP PBX?
03-16-2010 10:36 AM
I have my own IP PBX - Cisco UC560
05-07-2010 10:37 AM
Any progress on this? I am having the same issue trying to make changes
via the web interface
05-12-2010 09:07 AM
No luck yet. Someone mentioned that you have to enable the admin settings on the default XML file for the phone. I am the admin for our phones and UC560 system but have not figured out how to do that. If I knew how I have the credentials to do it, just not the knowledge! (I know, that can be a dangerous position to be in.)
07-06-2011 12:06 PM
im on the phone with the SBSC about this very issue, i think its rather ridiculous that this Cisco has not replied to this question.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide