cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

ipsec vpn question

martinipenburg
Beginner
Beginner

we have a modem in nat config before the uc500. we want to have ipsec vpn access to the uc500. do we have to open ports in the nat modem in front of the uc500? if yes which ports?

thanks.

martin

1 ACCEPTED SOLUTION

Accepted Solutions

Brandon Turpin
Cisco Employee
Cisco Employee

Hi Martin,

You will want to open UDP 500 (IKE) and 4500 (NAT-T).  You may also want to open ESP (protocol 50) in case NAT-T isn't supported on the remote end.

Thanks,

Brandon

View solution in original post

2 REPLIES 2

Brandon Turpin
Cisco Employee
Cisco Employee

Hi Martin,

You will want to open UDP 500 (IKE) and 4500 (NAT-T).  You may also want to open ESP (protocol 50) in case NAT-T isn't supported on the remote end.

Thanks,

Brandon

thank you for your answer Brandon.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: