05-25-2013 07:24 AM - edited 03-21-2019 07:23 AM
Hi,
I configured Jabber on a UC500 for some iPhone users. Jabber works pretty well, but numbers from the phones' contacts cannot be called directly, since a additional 0 before the actual number is required to dial outside the customers network.
Is there a way for automaticaly adding these zeroes to numbers called by Jabber extensions, while internal numbers can still be called?
I've looked into translation-profiles and dial-peers but didn't find anything suitable for my problem...
Kind regards,
Rainhard
05-26-2013 07:07 PM
here is a post of similar style that i have already started...
https://supportforums.cisco.com/message/3886100#3886100
Hopefully they will fix this in a release of Jabber!
UC540 system with 8.6.1 Software Pack
06-01-2013 07:57 AM
Hi,
I found a way to "fix" this problem! I configured a seperate COR list and dial-peer for the Jabber users without any translation of the called number. They can now directly dial their phone's contacts.
Kind regards
Rainhard
06-02-2013 03:18 PM
This is good news! Do you mind outlining the steps you did to do this
UC540 system with 8.6.1 Software Pack
06-03-2013 02:56 AM
Hi,
Here's what my configuration looks like:
! COR config
dial-peer cor custom
name JABBER
exit
dial-peer cor list call-JABBER
member JABBER
exit
! Dial-peer for outgoing jabber calls
dial-peer voice
...
corlist outgoing call-JABBER
...
exit
! For every jabber phone
voice register pool
...
cor incoming call-JABBER default
...
exit
Kind regards,
Rainhard
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: