cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2111
Views
0
Helpful
2
Replies

New PRI T1 setup, protocol questions.

Derek Thom
Beginner
Beginner

Hello-

I am setting up a customer with a UC560, and have never configured one for a PRI interface using a T1 WIC. The phone company has asked some questions that I don't know the answer to, and I have been unable to find clear answers after extensive searching. Here are their questions:

1) what protocol do you need to see NI 1, NI2, ATT, ? After searching, I am assuming NT2?

2) switch supervision required ? ( EM1 EM2 ) I did not find any information on this, so I do not know how to respond.

3) how many digits do you want to see (99% chose 4) It sounds like 4 digits? But again, I don't know how to respond.

Any help that can be provided is appreciated.

Thanks,

Derek

1 Accepted Solution

Accepted Solutions

Nathan Compton
Enthusiast
Enthusiast

Tell them the following:

Switch Type: NI2

Linecode: B8ZS

Framing: ESF

Digits: 4 is fine unless you have alot of DIDs

You may need to verify if you have control over Caller-ID.  This feature is called Calling Party Number.

View solution in original post

2 Replies 2

Nathan Compton
Enthusiast
Enthusiast

Tell them the following:

Switch Type: NI2

Linecode: B8ZS

Framing: ESF

Digits: 4 is fine unless you have alot of DIDs

You may need to verify if you have control over Caller-ID.  This feature is called Calling Party Number.

Thanks Nathan. I sent them this information. I appreciate the help!


Derek

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers