cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

583
Views
0
Helpful
1
Replies
gstoscano
Beginner

Problem FXO 3-4 (Not Registered)

Hi, we installed a UC320 client with two FXO lines (ports 1, 2),which were recorded successfully. Within a few weeks, try to adda new line, which is not recorded in any of the remaining ports(3.4).

If exchange and put the new line in 1 or 2 ports, works perfectly.

Any idea how to fix this?

Thank you very much for your help.

Gonzalo

Captura de pantalla 2011-11-28 a la(s) 09.53.14.png

1 ACCEPTED SOLUTION

Accepted Solutions
juliomar
Participant

Hi Gonzalo,

Please make sure that FXO3 and FXO4 are both enabled (checked) in the Ports and Trunks -> Line (FXO) Ports page of the UC320W Configuration utility.

If the ports are enabled, but fail to register the FXO trunk, please select to leave Feedback.  This will capture information from your device, and a support person can follow up with suggestions.

From your UC320W configuration utility on the upper right corner there is a cloud icon labeled Services, Select it and click on Feedback. Select Report Problems, enter the problem encountered, and an email address where we can reach you.

Best regards,

Julio

View solution in original post

1 REPLY 1
juliomar
Participant

Hi Gonzalo,

Please make sure that FXO3 and FXO4 are both enabled (checked) in the Ports and Trunks -> Line (FXO) Ports page of the UC320W Configuration utility.

If the ports are enabled, but fail to register the FXO trunk, please select to leave Feedback.  This will capture information from your device, and a support person can follow up with suggestions.

From your UC320W configuration utility on the upper right corner there is a cloud icon labeled Services, Select it and click on Feedback. Select Report Problems, enter the problem encountered, and an email address where we can reach you.

Best regards,

Julio

View solution in original post