Hi help me please. i have a problem whit the FAC (Force Autoritation Code). I set the dial-peer. However, when digit number, just take de Dial-Peer 101 Voip, asked the ID number and then the PIN number but, after dialing the key #, the call is cut.
dial-peer voice 101 voip
corlist outgoing call-CELULAR-LOCAL
preference 1
service clid_authen_collect
destination-pattern 9044..........
voice-class codec 1
session target ipv4:10.1.1.1
incoming called-number 9044..........
dtmf-relay h245-alphanumeric
no vad
ial-peer voice 51 pots
corlist outgoing call-CELULAR-LOCAL
preference 2
destination-pattern 9044..........
port 0/1/1
forward-digits 13
no sip-register
I put a "Show voice call status" and showme this:
UC520#sh voice call status
CallID CID ccVdb Port DSP/Ch Called # Codec MLPP Dial-peers
0x36A 1F0B 0x872DF234 50/0/11.0 5515125936 g711ulaw 20006/101
1 active call found
Namely take the dial-peer 101 but not take the dial-peer 51, and this is the port where the call goes out.
Thanks for help me