cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

601
Views
0
Helpful
1
Replies
ytamagawa
Beginner

Recovering static routing setting 10.1.10.1 for CUE

I'd like to recover connectivity with CUE.

I deleted default static routing setting 10.1.10.1 for CUE by my mistake.

I tried to configure like followings.

---

UC520#configure terminal

Enter configuration commands, one per line.  End with CNTL/Z.

UC520(config)#interface Loopback0

UC520(config-if)#description $FW_INSIDE$

UC520(config-if)#ip address 10.1.10.2 255.255.255.252

% 10.1.10.0 overlaps with Vlan101

UC520(config-if)#ip access-group 101 in

UC520(config-if)#ip nat inside

UC520(config-if)#ip virtual-reassembly

UC520(config-if)#interface Integrated-Service-Engine0/0

UC520(config-if)#description cue is initialized with default IMAP group

UC520(config-if)#ip unnumbered Loopback0

UC520(config-if)#ip nat inside

UC520(config-if)#ip virtual-reassembly

UC520(config-if)#service-module ip address 10.1.10.1 255.255.255.252

Need IP address to be configured on interface Integrated-Service-Engine0/0

---

It seems like ip adress setting failed because of overlapping with Vlan101. Also CUE Connectivity Diagnostics says "IP address needs to be configured on interface Integrated-Service-Engine0/0"

---

Use reset only to recover from shutdown or failed state

Warning: May lose data on the the NVRAM, nonvolatile file system or unsaved configuration!

Do you want to reset?[confirm]

Trying to reload Service Module Integrated-Service-Engine0/0.

UC520#service-module Integrated-Service-Engine 0/0 session

IP address needs to be configured on interface Integrated-Service-Engine0/0

UC520#

---

I'm a beginer of IOS, Cisco products and also English. I can barely use CCA. Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions
paolo bevilacqua
Hall of Fame Master

Check in flash there should be a default configuration file with basic settings.

View solution in original post

1 REPLY 1
paolo bevilacqua
Hall of Fame Master

Check in flash there should be a default configuration file with basic settings.

View solution in original post

This widget could not be displayed.