03-02-2011 07:08 AM - edited 03-21-2019 03:45 AM
Hello,
I am trying to set up a Asterisk configuration with several SPA504G in SIP mode. If the Asterisk PBX is configured the use SIP port 5060 a SPA504G logs on without problems. But if the Asterisk is configured to use the SIP port 5070, the SPA504G fails logging on.
Settings on the SPA504G:
Advanced_mode.Voice.Ext1.SIP_port: 5070
Advanced_mode.Voice.Ext1.EXT_SIP_port: 5070 or empty (tried both)
Advanced_mode.Voice.SIP.SIP_TCP_Port_Min: 5060
Advanced_mode.Voice.SIP.SIP_TCP_Port_Min: 5080
As said before, there is no problem registering if the Asterisk server is configured to use port 5060. Even if the settings in the SPA for Advanced_mode.Voice.Ext1.SIP_port is to use port 5070. It looks like the port 5060 is hard coded in the firmware of the SPA and the setting Advanced_mode.Voice.Ext1.SIP_port is not used.
If have no problems registering to Asterisk SIP port 5070 using other hardware (i.e. Siemens Gigaset Voip) or a Softphone.
Have I forgotten something and do I need an additional setting?
Regards,
Roy Damman
03-03-2011 03:11 PM
You want to register to port 5070. Then you would enter the ipaddress and port of the proxy in the proxy field like this example.
192.168.42.1:5070
You would put the above ip address and port of the asterisk into the proxy field of the phone.
03-03-2011 11:39 PM
That works !!! Thank you very much.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide