Repeating Error - VLAN Interface Settings are not synchronized across ...

[sreed]

Error Description from Primary Event Dailog box:

Description: VLAN Interface Settings are not synchronized across the following devices:
MobilSat-SW-02, MobilSat-SW-01, MobilSat_UC520

Recommendation: Click 'Resolve' to open the 'VLAN Interface Settings'
window and resolve this conflict

MobilSat_UC520 - UC520-32U-8FXO-K9

Expansion Port - 100/Full fixed

Uplinked -

GigiE - G2 - 100/Full fixed

MobilSat-SW-01 - ESW-520-24P - SW 2.0.3

GigiE - G1 Auto/Auto

Uplinked -

GigiE - G2 Auto/Auto

MobilSat-SW-02 - ESW-520-24P - SW 2.0.3

"Recommendation: Click 'Resolve' to open the 'VLAN Interface Settings'
window and resolve this conflict" - This opens VLAN Window where there aren't any options to modify, just Add / Delete.

Changed network cables several times.

Checked the configurations on the switches.

Configured for VLAN 1 (Data) as the Management VLAN.

Both VLANS 1 & 100 are Enabled on both Switches

[Steven Smith]

Do you have any other VLAN's configured on any of the devices?

If not, can you gather the CCA logs and attach them?

[sreed]

No VLANs other than the Default UC-520 VLANs

1 - Data - 192.168.10.0/30

100 - Voice- 10.1.1.0/30

[Steven Smith]

When looking through the logs, I see this quite often.

com.cisco.cpnm.frmwrk.net.DeviceException: 401: Authorization Failed

It looks like there might be some problems with CCA accessing the switches?  Can you delete them from the community and readd them?

[sreed]

Do I do this in the Connect settings in CCA?

Procedure?

[Steven Smith]

On the topology page, you should be able to right click on it and click remove from community.  Refresh the topology, add it back to the community.  That should bring up a page to put in your credentials.

[sreed]

Completed

here is the App Logs from the 'rediscovery' and subsequent login

[Steven Smith]

Is this a multisite deployment?

[sreed]

Negative - Single site

It is still 'Losing sync' and then resync's without any User action.

the three components are in the same Equipment Rack and as I said before the uplink cables have been replaced.

[Steven Smith]

Can you post a screen shot of the error?  Can you also post a screen shot of what it looks like when you try to resolve it?

Thanks

[sreed]

Word doc of screen captures of the Event Notification Screen and the VLAN screen that pops up if you click the Reslove button of the Event Notification.

Even if I select either VLAN the only options are to Add or Delete. Modify is never accessable.