cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

286
Views
0
Helpful
0
Replies
ccmadm1n1
Beginner

route calls UC560 to/from CUCM 4.1

How do I setup a trunk between a CUCM 4.1(3) and a UC560

DID's come into The CUCM then need to come over to my UC560

Calls from UC660 need to go to through the CUCM and out the PRI

PRI is already working with CUCM via 6608 blades in a Cat 6500

This worked before with a UC520 that is now gone - replaced with this UC560.

The CUCM config is still in place - looks like h323 trunks were used and maybe SIP

Not sure what is needed on the UC560 config and doubt I will be done using CCA 3? CLI only?

Sent from Cisco Technical Support iPhone App

0 REPLIES 0
Create
Recognize Your Peers
Polls
How would you describe your level of technical expertise?