I Would like to know if it is possible to set up a Softphone outside the network using the configuration i have:
I have set up a UC560 which is connected to a managed switch and a SRP527W Router (internet), I know you normally set up a VPN on the UC but is it possible to set up the VPN on the Router and still make it work?
If you would like to register the IPC from the WAN side you would need to open up the firewal. This would open up your network for hacking and toll fraud. You could consider some sought of LAN side VPN tunnel, however this has not been tested.
Not a recommended configuration and also a bad way of doing it.
You can consider doing the following:
Put the SRP in bridge mode and let the UC do the authentication and routing, and setup EZ_VPN and use the Drop Mode method... MUCH more reliable, secure and better process/standards for network security and reliability
Do some NAT/Port Forwards on the SRP of 500/4500 and point it to the UC500 and still setup EZ_VPN on the UC500, this would mean that you will need to setup the WAN port on the UC500 properly so it will work the way it is meant to
Not a method but a requirement:
Install Cisco VPN client on the client system and make sure that it has paths to all three VLAN's (Subnets) on the UC, so VLAN-1, VLAN-90 & VLAN-100 subnet's should be routable by the VPN client
That is the only two methods I would recommend and should be very doable in your scenario.
Just a thought for you to consider, otherwise you can do as Navin suggested but you expose yourself to Toll Fraud and other malicious activity.
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
Thanks for the advise. Quick question when you try a vpn it uses a port to try and connect right? can't I just portforward that port to the UC560 so it tries to authenticate there instead of the router?
Please let me know if that is possible or would the router just deny the vpn
SFP Module Support List for RV160x and RV260x Devices
Small form-factor pluggable (SFP) ports are included on the RV160 and 260 routers to allow the use of optical SFP transceiver modules. SFP’s convert the optical signals to electrical signals. SFP’s al...
Cisco is excited to offer its San Jose customers a unique opportunity to join us at Cisco headquarters for a design thinking workshop. This exclusive gathering, of no more than 20 people, is designed for an immersive interactive one-day session bet...
Welcome and thanks for visiting the Small Business Community Newsletter. This is our first of what we will make a monthly newsletter where you will be provided information on New products and trends, What’s ...
Hello @All ,
I am Bhuvi Chopra, a product manager on the Cisco Business (formerly SBTG) Team.
Cisco Business is excited to offer its San Jose customers a unique opportunity to join us at Cisco headquarters for a design thinki...
Join us on Thursday, November 14 at 10:00 am PT to learn more about how Cisco is empowering small business. From connectivity to cloud applications, networking plays a crucial role in every business journey. Cisco Business offers simple-to-deploy, fl...