cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

666
Views
0
Helpful
1
Replies
Joseph Sissell
Beginner

SPA 5xx Call Waiting Tone Length

I am struggling to shorten the Call Waiting Tone length on a Cisco SPA514g, running sofware ver. 7.5.3, hardware ver 1.0.0.

I am using the Metaswitch SIP Provisioning server to send a custom config fragment <Call_Waiting_Tone>440@-5;1(.1/.1/1)</Call_Waiting_Tone> to the phone.

I have verified via the phone ui that the value is successfully entered in the "Call Waiting Tone" field under the "Regional" tab. The tone length never changes. I can remove it altogether, but not affect the -db levels or the length.

Any ideas or suggestions?

1 REPLY 1
jamesENye
Beginner

I've recently ran into this issue also.  I found it happens whenever I set my remote media gateway model to anything other then the default ringtone I get the extremely long CW beep.  When I set it to the default Cisco Synth tone the tone follows the config UI you stated above.

Create
Recognize Your Peers
Polls
How would you describe your level of technical expertise?