I have a SPA400 in place for years but was only using it for voicemail which worked great.
Lately I needed to reconfigure it to work with a single analogue line plugged into Line 1. But the SPA400 showed the line as On-Hook with 0V (somethimes it shows off hook with 0V). I have tried all the other analogue ports with the same result.
After a full factory reset and a setup (both manual & wizard) the SPA400 still showed the same problem. I found that if I just kept restarting the device it would eventually detect the analogue line @55V. If it stayed running after this it would be OK but it also loses the analogue line after a random period of time.
Locale is Ireland.
Firmware is 188.8.131.52
SPA400 Config Attached
Has anyone seen this snag before and can it be fixed?
QuestionDear All,I'm currently looking for firmware version 184.108.40.206 for Linksys SPA400 Analog Telephony Gateway. Unfortunately, my device was bricked and I was able to recover it using a recovery tool and recovery firmware version 220.127.116.11 but can't find v...
Change in ASD Automatic Software Download Feature
Dec 13th, 2019
Cisco RV160, 260, 340, and 345 Series Routers
Due to an API change in Cisco’s software download platform the Automatic Download Feature (ASD) on RV series routers will be temporarily ...
SFP Module Support List for RV160x and RV260x Devices
Small form-factor pluggable (SFP) ports are included on the RV160 and 260 routers to allow the use of optical SFP transceiver modules. SFP’s convert the optical signals to electrical signals. SFP’s al...
Welcome and thanks for visiting the Small Business Community Newsletter. This is our first of what we will make a monthly newsletter where you will be provided information on New products and trends, What’s ...