cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4275
Views
0
Helpful
2
Replies

SPA400 loses or doesnt detect analogue line

gavin.tobin
Level 1
Level 1

Hello,

I have a SPA400 in place for years but was only using it for voicemail which worked great.

Lately I needed to reconfigure it to work with a single analogue line plugged into Line 1. But the SPA400 showed the line as On-Hook with 0V (somethimes it shows off hook with 0V). I have tried all the other analogue ports with the same result.

After a full factory reset and a setup (both manual & wizard) the SPA400 still showed the same problem. I found that if I just kept restarting the device it would eventually detect the analogue line @55V. If it stayed running after this it would be OK but it also loses the analogue line after a random period of time.

  • Locale is Ireland.
  • Firmware is 1.1.2.2
  • SPA400 Config Attached

Has anyone seen this snag before and can it be fixed?

Regards,

GT

2 Replies 2

nseto
Level 6
Level 6

The default line impedance setting is 600 for U.S.  Ireland should be 270+750||150nF.  Try that change and see if it detects the line properly.

I already have that set.

Moved up to 1.1.2.3 and still have same problem.

It is random but multiple restarts or power cycles eventually gets the line up.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: