05-12-2010 02:12 AM - last edited on 03-25-2019 10:50 PM by ciscomoderator
The only reason I ask is that I don't see it specifically listed here:
http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/vcallcon/ps4625/data_sheet_c78-567246.html
And not addressed in the FAQ either:
http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_qanda_item09186a0080875c6f.shtml
I have a potential customer who currently has 100 phones, so w/ projected growth, a UC560 wont cut it. I'm looking at a 3845, and I'd like to save them a few bucks and get 502's and 504's. I did notice their phone loads were NOT in cme-150-1XA1.zip.
Thanks in advance,
Jeremy
05-25-2010 10:49 PM
Hi Jeremy,
according to the FAQ here: http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/phones/ps9730/qanda_c67-466070.html
Cisco IP Phone 500 are supported only on Cisco Unified Communications 500 Series:
Regards,
Vladimir
05-26-2010 04:12 AM
Just too add... SPA5xx runn either SIP or a version of SCCP we call SPCP. Its a tokenized version of SCCP which only works with UC500. It is not intended for use on CME ISRs or higher. The same with CP52x except it wont do SIP.
For investment protection, SPA5xx is reusable on managed (Hosted) IP PBX offerings.
Steve
05-26-2010 11:14 AM
Thanks guys. Very helpful
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: