cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
10022
Views
0
Helpful
6
Replies

SPA509G & BLF & Asterisk

cinglalls
Level 1
Level 1

Hi,

It's possible to configura a line key 1 with an extended function like

fnc=blf+sd+cp;sub=200@172.18.20.22;nme=Ext 200

in order to monitor the extension 200 without an attendant Console?

I did it on an spa942 and spa962 but i don't know if it's possible on a SPA5XX

Thanks in advance

6 Replies 6

Alberto Montilla
Cisco Employee
Cisco Employee

Dear Sir;

Yes, it is possible.

Regards
Alberto

I try it, but the led is all the time orange.

My Configuration is:

Extension: Disabled

Share Call Appearance: Shared

Extended Function: fnc=blf+sd+cp;sub=200@172.18.20.22;nme=Ext 200

Short Name: 200

Server Type: Asterisk

The Call Pickup and BLF doesn't work Speed Dial Works fine

Can you help me?

Hi cinglalls,

At asterisk's CLI, type: core show hints

This will tell you who is watching what

Verify that you've a hint in the extensions.conf file.

Example:

SPA509 has the following configuration to subscribe and monitor extension 508:

     fnc=blf+sd+cp;sub=508@192.168.2.245;nme=508

The extensions.conf has the following:

exten => 508,1,Dial(SIP/508,10,rT) ;ring for 10 seconds
exten => 508,hint,SIP/508 ; hint: core show hints *CLI sees extension state
exten => 508,2,VoiceMail(508@default,u)
exten => 508,3,hangup
exten => 9508,1,VoiceMailMain(508) ;mailbox access for extension

Make sure that the sip.conf allows your phone to subscribe to extension 200's state. Continuing my example, sip.conf snippet:

; allow phone to subscribe to another phone's extension state
allowsubscribe=yes
notifyringing=yes
limitonpeer=yes
notifyhold=yes
;

Regards,

Patrick

----------

Hi,

I put the other unused extensions to disabled and it works.

Thank's for your help.

Hi,

I have a SPA504G and I'm trying to configure BLF with Elastix 1.6.

I can make a speed dial but the ligth is off.

FYI, I had the same type of problem (getting the last 4 line keys to be BLF+SD on a SPA509G), and disabling the unused lines did not help.  It turned out the attendant console units were enabled in the config, but I did not have any SPA500S units attached.  Disabling the two consoles in the config made BLF on the line keys work again.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: