I've been trying to figure out how to offset the light pattern of the LED's on the phone.
We have about ten SPA509G phones running, but when someone is on the light, or when everyone is on the phone, they light up red on all of the lines. If a call comes through, it blinks red everywhere. I've been trying to figure out how to change this behaviro. If you don't already know who is on the phone, then there is no way to know if you should asnwer it, or if someone else will.
I found the
Settings, along with following
http://sbkb.cisco.com/CiscoSB/GetArticle.aspx?docid=d730bf19c1374db1a593591870245eb1_Configure_Line_Key_LED_Pattern_on_SPA9x2_Series_IP_Phones.xml&pid=2&converted=0
I figured out how to make local lights (lights which correspond to the user) works. I however have been unable to get the Remote LED's to do what I want.
As an example for one of the LED selectors:
The Shared Call Appearance is set to Shared; while Extension is set to Disabled.
Does anyone have any idea as to what I could edit, or MacGyver to get this to work the way we need it too?
Thanks.