cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

SPA942 with attached PC: Voice VLANS

beckerli
Beginner
Beginner

I wish to provide QoS best practice by configuring seperate VLANS for data and voice. I am using the SRW208P switch. With the 7940 IP phone and a catalyst switch one would trust CoS and trust device cisco Phone and configure an Aux VLAN at the switch.  Can anyone assist me with the equivalent using the SMB hardware?

1 ACCEPTED SOLUTION

Accepted Solutions

Patrick Born
Cisco Employee
Cisco Employee

Hi beckerli,

The SPA9000 Installation Guide addresses QoS/CoS on a switch which you may find relevant to your SPA942 question:

http://www.cisco.com/en/US/docs/voice_ip_comm/csbpvs/spa9000/installation/guide/spa9000_voice_system_webui_ig.pdf

The SRW208P's admin Guide will also be of use to you:

http://www.cisco.com/en/US/docs/switches/lan/csbms/srw2008/administration/guide/SRW2008_V10_UG_B-WEB.pdf

Here's a document about VLANs and DSCP in a small business env. that you may find interesting:
https://www.myciscocommunity.com/docs/DOC-7433

The SPA942 by default marks SIP with a ToS/DiffServ value of 0x68 and RTP with 0xb8 [DSCP cs3 and ef respectively]

Configure at phone's web-ui > Ext N tab > Network Settings >

[click image to view]

cap-844.jpg

By default, the phone does not have VLANs enabled and does not tag the PC port data either.

Configure at: System tab > VLAN Settings >

[click image to view]



cap-843.jpg

Regards,

Patrick

--------

View solution in original post

2 REPLIES 2

Patrick Born
Cisco Employee
Cisco Employee

Hi beckerli,

The SPA9000 Installation Guide addresses QoS/CoS on a switch which you may find relevant to your SPA942 question:

http://www.cisco.com/en/US/docs/voice_ip_comm/csbpvs/spa9000/installation/guide/spa9000_voice_system_webui_ig.pdf

The SRW208P's admin Guide will also be of use to you:

http://www.cisco.com/en/US/docs/switches/lan/csbms/srw2008/administration/guide/SRW2008_V10_UG_B-WEB.pdf

Here's a document about VLANs and DSCP in a small business env. that you may find interesting:
https://www.myciscocommunity.com/docs/DOC-7433

The SPA942 by default marks SIP with a ToS/DiffServ value of 0x68 and RTP with 0xb8 [DSCP cs3 and ef respectively]

Configure at phone's web-ui > Ext N tab > Network Settings >

[click image to view]

cap-844.jpg

By default, the phone does not have VLANs enabled and does not tag the PC port data either.

Configure at: System tab > VLAN Settings >

[click image to view]



cap-843.jpg

Regards,

Patrick

--------

Hi Patrick, thank you for your prompt and very thourough reply and going to the effort of directing me to all the necessary resources. It has helped me arrive quickly at a solution for my client.  You are an asset to the Cisco community!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: