cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

1005
Views
0
Helpful
2
Replies
mziskind1
Beginner

SSL VPN ERROR REMOTE TELEWORKER (Can not select private key)

Hi All,

I am unsuccessfully trying to set-up a remote teleworker phone.  I have set up the SSL VPN full tunnel mode. Installed anyconnect package 2.5.3055. Using softwware pack 8.2.  Phone is 525g2.

Each time I try to connect to the VPN I receive an error on the phone. The SSL VPN debug log shows the message "Can not select private key ( < fqdn of the UC540 > )". 

I have disabled the firewall and tested with the same result. 

Anybody know how to remedy this one? 

Thanks!

2 REPLIES 2
Darren DeCroock
Enthusiast

Hello,

I would suggest trying to remove the trustpoint,then recreate, and re-enroll...  This can only be done though CLI...

no crypto pki trustpoint TP-self-signed-xxxxxxxxxx     <-- Replace xxxxxxx with number from config.

crypto pki trustpoint TP-self-signed-xxxxxxxxxx     <-- Replace xxxxxxx with number from config.

enrollment terminal
subject-name cn=www.ansc-inc.net
revocation-check none
rsakeypair TP-self-signed-xxxxxxxxxx     <-- Replace xxxxxxx with number from config.


cry pki enroll TP-self-signed-xxxxxxxxxx     <-- Replace xxxxxxx with number from config.
  NO
  NO
  Yes

Thank you,

Darren

Thanks Darren.  That was enough to get it straightened out.