cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.
Get the latest news in this issue of the Cisco Small Business Monthly Newsletter

470
Views
0
Helpful
2
Replies
Beginner

Two sites, UC520 at each site

If I have two sites (main & remote - within same city), both with an UC520 at each site, can I utilize the SIP trunks at the main site for both inbound and outbound calls for the remote site?  In another words, say I have 2 DIDs.  I'd like to assign one DID to ring at the main site and second DID to ring at the remote site.  Is this possible with custom dial-peers and translation profiles?

IPsec VPN will be established between the two sites.  I will provide both sites with POTS as a backup incase of SIP or VPN failure.

Are there any sample configs I can refer to?

Everyone's tags (7)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

Re: Two sites, UC520 at each site

Yup, you can do that.  You are just going to have a dial-peer which points from the remote CME to the HQ CME for the PSTN numbers.  And conversely, you'll have dial-peers on HW to point the remote site's DIDs back to that device.

View solution in original post

2 REPLIES 2
Highlighted
Cisco Employee

Re: Two sites, UC520 at each site

Yup, you can do that.  You are just going to have a dial-peer which points from the remote CME to the HQ CME for the PSTN numbers.  And conversely, you'll have dial-peers on HW to point the remote site's DIDs back to that device.

View solution in original post

Highlighted
Beginner

Re: Two sites, UC520 at each site

Great. thanks