cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
1022
Views
0
Helpful
0
Replies
Highlighted
Beginner

UC 560 Time Zone Mismatch with 7975 and 7965 IP Phones

Hi There,

i have a scenario : Cisco UC560 connected to 7965G and 7975 IP Phones. In my UC 560 system clock  as follows:

UC560X#show clock

14:18:11.456 GMT Tue Jul 17 2012

UC560X#service-module i0/0 se

Trying 10.1.10.2, 2002 ... Open

se-10-1-10-1#

se-10-1-10-1# show clock

14:18:29.157 GST Tue Jul 17 2012


UC560#sh ntp status

Clock is synchronized, stratum 3, reference is 18.7.21.144

nominal freq is 250.0000 Hz, actual freq is 249.9992 Hz, precision is 2**28

reference time is D3AFBAA7.D0452C16 (14:19:19.813 GMT Tue Jul 17 2012)

clock offset is 24.5711 msec, root delay is 208.40 msec

root dispersion is 40.74 msec, peer dispersion is 1.18 msec

loopfilter state is 'CTRL' (Normal Controlled Loop), drift is 0.000002907 s/s

system poll interval is 64, last update was 60 sec ago.

Here the problem which is facing : Cisco 7975G show time 10:22 (though the current time is 14:22 ,we are located at GMT +4) and current time 7965 : 15 :24 (1 hour more)

I have gone through all the the possible clock settings make things done. i am afraid to see that when console notification messages follows the time of 7975 ip phones .

Please revert back if anyone have any suggestions.