Greetings all,
We're about to plug our T1 line into our new UC 560 w/ the T1E1 card. We've changed the settings to the proper T1 type in our CCA.
Do we need a straight pinned or cross pinned cable? We have a Verilink CSU/DSU, if that matters. There's a pinout printed on the CSU device itself, which is as follows (it has a 15 pin output):
1 - Send In (Tip)
9 - Send In (Ring)
3 - Receive Out (Tip)
11 - Receive Out (Ring)
2 - Chas Ground
4 - Chas Ground
Thanks all!