cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Announcement“Cisco Design Thinking Workshop”. Cisco Small Business is excited to invite its Silicon Valley customers to an exclusive interactive one-day session between customers and product Managers.  If you are interested in this exclusive workshop, please fill out the Registration Form. For more information, please check out our FAQ


Get the latest new and information the November issue of the Cisco Small Business Monthly Newsletter

1188
Views
0
Helpful
3
Replies
Beginner

UC320 - cannot load setup page after factory reset

I have a UC320 that we are using for demos. I performed a factory reset on the unit to prepare for a fresh install.

Now after logging in with cisco/cisco I am shown the "loading new configuration" however it never goes any further.

In capturing packets I see a lot of 404 errors coming from the UC320 while the "loading" bar is scrolling towards 100%

This box has had a few setups done and always set back to factory defaults. Not sure what has changed but without cli access I have no idea how to proceed.

tia

3 REPLIES 3
Frequent Contributor

UC320 - cannot load setup page after factory reset

Hi,

Please put a call into the Small Business Support Center where they have some advanced tools to help recover your box.  You will need to have LAN side connectivity to the unit when you call them.

Thanks,

Chris

Highlighted
Beginner

UC320 - cannot load setup page after factory reset

Hi

Did you get this resolved ? I have the same problem as yours.

Thanks

Beginner

UC320 - cannot load setup page after factory reset

I did, I had to call the small business support group and have them reload everything.

They logged into a web page on the box that we as consumers do not have access to and was able to restore it.

I really wish access to the advanced pages would be given to partners. It is a major handicap and I think looks bad on partners when we need to call support to do a simple restore...