We have an UC320W with polycom SS2w
UC320W software is 2.3.2
FXS port is enabled
Polycom has been assigned an extension via UC320 GUI.
Whole service rebooted after the config was applied.
Issue : No dialtone or ability to call internal extensions from the polycom, unable to call the internal extension from another handset...
Is there further programming required via the polycom ?
Is there any way to test ?
No FXO ports are in use ..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: