cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

UC500 and Stonefax

jcartier
Beginner
Beginner

Hi All,

I'm having an issue where I'm trying to setup StoneFax into our existing enviroment and its not taking to it at all...

The StoneFax system guide, I feel, is rather light on setup examples.  It does give an example of the following...

voice service voip
fax protocol t38 fallback pass-through g711alaw
!
dial-peer voice 1 voip
description INCOMING FAX FROM PSTN TO STONEFAX
destination-pattern 4..
session target ipv4:10.10.10.1
session protocol sipv2
codec g711alaw
no vad

I've followed this example to no avail.  My question is, if I have a DID that I want to map to my fax # how do I go about doing so?

I created another dial-peer and used the incoming number and a voice translation profile to map it to a 4xx number; but that didn't work.

Does anyone have any experience setting up stonefax?

3 REPLIES 3

Marcos Hernandez
Collaborator
Collaborator

The dial peer that you need to create is a POTS one. Did you do this?

I think I've finally got it all worked out :)

Report back in a little bit

Hi,

The last note here was that you think you got it fixed.  I am having an issue setting a test environment for this with using SIP.  The dial-peer seems to be working fine as I can send faxes out, but I can't receive it.

Can you tell me what you did to fix it so I can test on my side.

Thanks!

Chris

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: