cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Announcement“Cisco Design Thinking Workshop”. Cisco Small Business is excited to invite its Silicon Valley customers to an exclusive interactive one-day session between customers and product Managers.  If you are interested in this exclusive workshop, please fill out the Registration Form. For more information, please check out our FAQ


Get the latest new and information the November issue of the Cisco Small Business Monthly Newsletter

841
Views
0
Helpful
4
Replies
Beginner

UC520 8.6 bind commands breaking MWI

As some of you may know, software pack UC520 8.6 adds 2 bind lines in the config -

voice service voip

sip

  bind media source-interface Vlan100

  bind control source-interface Vlan100

These above lines are required to register SIP based phones such as 9971 or Iphones.   Unfortunately having these lines in the config also causes MWI to stop working. 

What is a standard setup/config to have both SIP phones registered and MWI working simultaneous?

Thanks in advance

Everyone's tags (4)
4 REPLIES 4
Cisco Employee

UC520 8.6 bind commands breaking MWI

the issue will be next CCA 3.2.2,

for now, you can just remove these 2 lines, this is for remote teleworker access only, and 9971 not support remote teleworker with UC500. other thank this everything will be fine include MWI.

bind media source-interface Vlan100

  bind control source-interface Vlan100

Cisco Employee

UC520 8.6 bind commands breaking MWI

after remove, dont forget

vocie register global

create profile

then phone will be reset.

Highlighted
Beginner

UC520 8.6 bind commands breaking MWI

Bongsu,

Are you saying SIP phones such as 9971 do not depend on those 2 lines for it to work?  So I can remove the two bind lines and get a 9971 or Iphone working?

Cisco Employee

UC520 8.6 bind commands breaking MWI

yes, correct