I have GUI access to CUE on a UC520 but cannot reach the GUI to the CCME.
When trying to access CCME GUI from the CUE GUI (10.1.10.1) I can see:
Note: Use this page to change the CallManager Express the system is registered to. To change the username or password of the current CallManager Express go to Configure > System Parameters > Administrator's Login Account.
Cisco Systems
Accessing Cisco UC520W-8U-4FXO-K9 "UC520"
Show diagnostic log - display the diagnostic log.
Monitor the router - HTML access to the command line interface at level 0,1,2,3,4,5,6,7,8,9,10,11,12,13,14,15
Show tech-support - display information commonly needed by tech support.
Extended Ping - Send extended ping commands.
Help resources
- CCO at www.cisco.com - Cisco Connection Online, including the Technical Assistance Center (TAC).
- tac@cisco.com - e-mail the TAC.
- 1-800-553-2447 or +1-408-526-7209 - phone the TAC.
cs-html@cisco.com - e-mail the HTML interface development group
Note: Use this page to change the CallManager Express the system is registered to. To change the username or password of the current CallManager Express go to Configure > System Parameters > Administrator's Login Account.
When trying to access the CCME GUI using the IP address assign to it (10.1.10.2) the following is displayed:
Cisco Systems
Accessing Cisco UC520W-8U-4FXO-K9 "UC520"
Show diagnostic log - display the diagnostic log.
Monitor the router - HTML access to the command line interface at level 0,1,2,3,4,5,6,7,8,9,10,11,12,13,14,15
Show tech-support - display information commonly needed by tech support.
Extended Ping - Send extended ping commands.
Help resources
- CCO at www.cisco.com - Cisco Connection Online, including the Technical Assistance Center (TAC).
- tac@cisco.com - e-mail the TAC.
- 1-800-553-2447 or +1-408-526-7209 - phone the TAC.
cs-html@cisco.com - e-mail the HTML interface development group
Please let me know if you have found this and have any solution.
Thanks,
