Hi All,
Looking for your advice since Cisco TAC could not help me on my puzzle.
I have a UPC Internet 40Mb Down and 4Mb Up Static IP Connection.
Configured the UC520 Firewall set to Low inspection > When I do a speedtest while the laptop is connected to the UC520 via ethernet - I get the full bandwidth I would expect.
When I connect the laptop via wirelss and perform the same test I only get 17Mb Down and 4Mb up.
can anyone tell me why I have lost over 50% of my bandwidth?
I have copied the 2 interfaces below:
!
interface Dot11Radio0/5/0
no ip address
!
encryption vlan 1 mode ciphers tkip
!
ssid OceanCity_PL
!
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
station-role root
antenna receive right
antenna transmit right
world-mode dot11d country PL indoor
service-policy output Voice
!
interface Dot11Radio0/5/0.1
encapsulation dot1Q 1 native
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
I see a service-policy about Voice - I dont use voice over wireless - Could this be causing the issue?
Thanks in advance
Brian
