02-23-201208:54 AM - last edited on 03-25-201911:02 PM by ciscomoderator
I have looked through the CCA version 3.2 for a way to configure the 79xx series phones "Power Save Configuration" settings. The 79xx phones the customer uses are the 7945 and 7965. For those who are unaware of this feature it turns the LCD screen off on a predetermined schedule chosen by Cisco. The default settings in the phones are as follows:
1. Display On Time: 7:30
2. Display On Duration: 10:30
3. Display Idle Timeout: 01:00
4. Days Display Not Active: Sunday, Saturday
5. Display On If Incoming Call: Disabled
These settings are fine for a typical business, but what about customer who is open 7 days a week or with extended hours. The phones "Power Save Configuration" should be set to the uc540 system schedule. If there is a supported way configuring through the CLI that would also be great. Any help would be appreciated thank you.
After working with support I was told "In researching this issue I’ve come across the CLI settings for configuring it but could not get it working in my lab and it is not something we can spend time supporting if you’re not CLI specialized.". So I went into the CLI and found enough information that led me to the commands I used to solve my issue. I've tested the commands below on my uc540 and on a customers uc540 without any issues. Anytime you use the CLI make sure you back up your equipment. The information below is to configure the "Power Save Configuation on 79xx Phones" To verify the settings on a 79xx phone go to Settings --> Device Configuration --> Power Save Configuration.
User Access Verification
Configuring from terminal, memory, or network [terminal]? terminal
Enter configuration commands, one per line. End with CNTL/Z.