UC540 password lost

[link4voip]

Hello ,

I lost the user name and password for UC540

How i can restet the password or make reset factory settings ?

Regards ,

[danplacek · Accepted solution]

http://www.cisco.com/en/US/products/hw/routers/ps259/products_password_recovery09186a0080094675.shtml

Those instructions are pretty detailed.

Let us know if you have any questions.

-Dan

Please rate useful posts.

[link4voip]

When I connect by using putty its asking for user name as you can see below :

Can I give you access by team viewer and help me please ?

[Yasien Adams · Accepted solution]

Mohamed,

you need to break that boot-up sequence, so that it bypasses the username config.

eject the flash card, that will put you at ROMON

You can use the following method to recover password.

NOTE** Before breaking into ROMMON, make note of the config register, though its probably 0x2102

1/     Power down the UC

2/     Eject flash card

3/     Power up UC, it will start into ROMMON

4/     at ROMMON1 enter confreg 0x2142 (remember to reinsert the flash card)

5/     type reset (UC will boot, ignoring config)

6/     press N for initial setup prompts

7/     at router prompt type enable

8/     copy startup-config running-config

now you are back in your normal config, so you can modify the accounts, and enable secret

also make sure you bring your interfaces back online, as it will be in shutdown mode.

once you have made all your changes

9/     type config-register 0x2102

10/     then write memory

ALL DONE !!

[link4voip]

I failed to reset the passsword

can you please add skype: almodamer911

to give you access by team viwer

[Yasien Adams · Accepted solution]

email me your teamviewer details, i will have a look.