01-28-2011 07:37 PM - edited 03-21-2019 03:35 AM
I have two issues when adding a Co Line to a buttons on phones.
1 When I assign a Co Line to a button I cant change the label.( Example Co line 1. to say something like metro, for the user to know its a metro line.)
2nd when I am assigning Co lines from the drop down list it gets confused.
The drop down should look like this.
CO line 1 (0/1/0)
CO line 2 (0/1/1)
CO line 3 (0/1/2)
CO line 4 (0/1/3)
But it comes out like this or something close to it and the wrong line is ringing on the button.
CO line 1 (0/1/0)
CO line 3 (0/1/1)
CO line 2 (0/1/2)
CO line 4 (0/1/3)
The phone button will display line 2 but its actually line 3.
01-29-2011 04:49 AM
How did the look in the incoming Dial Plan screen?
https://supportforums.cisco.com/docs/DOC-14830
I checked the release notes and didn't see this as a known issue...
http://www.cisco.com/en/US/docs/net_mgmt/cisco_configuration_assistant/version3_0/release/notes/cca_30_relnotes_OL23762-01.html
Perhaps you can make some screen shots if the DP, the Trunk ports status and the phone buttons?
Steve
01-30-2011 06:43 AM
Here is a screen shot of the 2.2 CCA here I am able to change the lable of the line. In CCA 3.0 it will not allow me to edit this field.
01-30-2011 06:45 AM
01-30-2011 06:47 AM
I will have to get screen shots of the lines that are mixed up on Monday.
01-31-2011 02:05 AM
One of the engineers informed me that a similar issue was reported Last week, and it has been identified as bug, CSCtl88964 and has been fixed in upcoming 3.0(1) branch.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide