05-21-2012 07:13 PM - edited 03-21-2019 05:49 AM
I have a full PRI with AT&T 23B+1D, running in primary-ni mode, north american 7-digit. I am able to place local and national calls but unable to dial international. I dial 9 then 011 then the international number get a fast busy signal. I have a ticket opened with AT&T they keep sending the ticket to a translation group but have not heard back yet. I can see the international dial plan within CCA. What can I do to check that it is not the phone system having this issue.
Software pack 8.2
Solved! Go to Solution.
05-21-2012 09:57 PM
try
interface x/y/z:23
isdn map . unknown unknown
I whish Cisco would understand once for all that what they are doing with silently changing plan/type is simply wrong.
05-21-2012 09:57 PM
try
interface x/y/z:23
isdn map . unknown unknown
I whish Cisco would understand once for all that what they are doing with silently changing plan/type is simply wrong.
05-21-2012 10:44 PM
Well that definetly fixed it I ran "isdn map address 011.* plan unknown type unknown"
05-21-2012 10:48 PM
Very good, thanks for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: